Silicon-Silicon Carbide (Si/SiC) Power Devices for high temperature, hostile environment applications

Completed

Energy Efficiency(Other)
Renewable Energy Sources(Solar Energy, Photovoltaics)
Fossil Fuels: Oil Gas and Coal(Oil and Gas, Other oil and gas)
Not Energy Related

Basic and strategic applied research

ENGINEERING AND TECHNOLOGY (Electrical and Electronic Engineering)

Not Cross-cutting

Dr PM Gammon
School of Engineering
University of Warwick

Standard

EPSRC

01 December 2015

31 May 2018

30 months

£99,058

Info. & commun. Technol.

West Midlands

NC : ICT

Dr PM Gammon, School of Engineering, University of Warwick

Project Contact, Semelab Plc
Project Contact, Halliburton KBR

Several problems facing society in the 21st century share a common problem: that when electronic devices heat up, they become inefficient, wasting energy. It is therefore the case that in your laptop there is significant space, weight and significant design cost associated with implementing the right cooling system to efficiently extract the heat. The laptop is however, a relatively low-power system, operating on earth at a rather pleasant 20C room temperature. Engineers are regularly facing this problem on a much larger scale, in much ambient temperatures, and in a situation where it is often difficult, expensive and often highly impractical to implement active cooling.Oil and gas engineers, attempting to harvest the fossil fuels we are still highly dependent on, face exactly this problem with the electronics that are driving the cutting tool motor. Power electronic devices delivering hundreds of Watts of power to the motor must do so in an ambient that can exceed 225C, operating miles under the ground with only slurry pumped from the surface to cool the devices. Similarly, electric cars are forced into restrictive design choices keeping the electronics as far from the engine as possible to minimise the cooling requirements. In space, near-sun planetary explorers are essentially floating refrigerators, the inner cabin cooled, at great cost to eventual mission length, down to earth-like temperatures when the temperature outside can exceed 300C around Venus or Mercury. The potential benefit for having electronics operating in these environments without cooling is huge, leading to greater efficiency, reliability and mission length, saving space, weight and importantly cost.This project looks to redesign the silicon device and to push its thermal behaviour to the absolute limit, so minimising the need for cooling, or eliminating it entirely. This is to be done by combining it with another material, silicon carbide, that will act as a heat sink placed within fractions of a micro-meter of the active device itself. These new Silicon-on-Silicon Carbide (Si/SiC) devices are expected to offer gains in device efficiency over any existing silicon device operating at elevated temperature. Alternatively, the same level of performance could be retained as with existing solutions, except at temperatures as much as 100C higher, or at much higher power (as much as 4x).The power transistor, implemented entirely with the silicon thin film, is a laterally-diffused metal-oxide-semiconductor field effect transistor (LD-MOS) or a lateral insulated gate bipolar transistor (L-IGBT), similar to those that have been developed for silicon on insulator (SOI) or silicon-on-sapphire. These devices shall be optimised for breakdown voltages rated from 50 to 600 V, making the devices ideal for applications such as downhole motor drives required by project partner Halliburton, and for solar array inverters destined for space.

04/08/15